Working with electrical frameworks can be perilous. It’s a smart thought to contract an expert to address any association related issues. Luckily, there is one fix you can make without the assistance of an expert. Swapping out defective or confounded breakers is a straightforward activity that doesn’t require working with risky electrical frameworks. Here’s a fast how-to:
Tools Needed
Flat-head or Philips-head screwdriver
Remove the panel cover. Remove the screws holding the panel cover in place. As you loosen the screws, be careful not to damage any wires resting on the screws themselves. This can cause a short circuit.
Cut the power. Flip the main breaker to turn off the power to your breaker box.
Test the breaker. Use a stick tester to test each wire attached to your breaker. Only continue working if both wires are without power.
Loosen the terminal. Use the flat-head screwdriver to loosen the terminal screws. Pull the wires away from the breaker terminal.
Remove the breaker. Push on the front of the breaker handle to remove the breaker from the slot.
Install the new breaker. Line up the new breaker with the clips on the side of the bus bar. Push down firmly to snap the breaker in place. Reconnect the terminal wires and screw them in place.
Turn on your breaker. Flip your breaker switch and test the terminal wires with the stick tester to make sure your breaker has power.
